I use a square to align the fence to the table bed. However, I then have to lock it into position using the lever-lock screw shown. Just as I get to the 'tightening point' the fence will tilt backwards away from the table.

• Elektra Beckum Planer Thicknesser Hc260 Manual Transfer Case
• Elektra Beckum Hc 260 Manual
• Elektra Beckum Planer Thicknesser Hc260 Manual Transfer System

It moves a good 2-3 degrees. There seems no way to keep the thing square to the table. If I just nip up the lock screw to just before the point where it shifts, then the fence is not held tightly enough and it will move during operation. So I have been trying to angle the fence slightly acute to the table bed, in the hope that this will bring the thing back into square during the final tightening.

As you can imagine, this is hit or miss and most of the time the fence is not square. I think I may be spending more time playing with the fence than I am planing timber.I am leaning towards the conclusion that the fence locking mechanism is poorly designed and that this is, for once, not user error. Does anyone have any suggestions as to how to bring some sort of functionality back to the fence. I wondered if there was some sort of 'after-market' fix.Thanks again. MikeJhn wrote: Steve Milne wrote: MikeJhn wrote:Put a plywood face on it at 90 deg when its locked, easy to plane up a bit at 2-3 deg.Not a bad idea, but that assumes that the tilt is a consistent 2-3 degrees during the tightening. I am not convinced that that is the case.It actually assumes that the tilt is constant once tightened.Ah, yes. Sorry for the misunderstanding.

Nov 24, 2016  WIC Reset Key 2017 is ideal to reset your printer if your suddenly stop working and showing ink flow and Key blockage errors. A single key with WIC Reset can be used for all the supported modals of the printers. The process of resting the ink counters is very easy and simple and you have to just download and run WIC Reset Utility on your system. Wic Reset V 3.75.90 Serial Number Key. Although it is free, it still can reset the waste ink counters up to 90%. Wic reset key for epson l120 cracked l220 resetter enter reset key. Buy the key, and after few minutes the counter was reset! In case your waste ink pads are placed at the base of the printer, it is very difficult to do that. The WIC RESET KEY is for ONE RESET only. You have to buy a new Wic Reset Key each time you need to reset another printer or you can get FREE RESET KEY and reset WIC to 90% – So You can continue Your printing job in few seconds! Get TRIAL WIC Reset Key here This TRIAL Reset Key will work ONE TIME for each printer device.

Elektra Beckum Planer Thicknesser Hc260 Manual Transfer Case

Do you think that the fence would hold that position then and never need adjusting again? ( I do need to remove the fence for thicknessing operations.) If so, then it is a viable option. Footer with it, until you hit 90, then scribe a line across the side face of the locking bracket and trunnion? If you then slowly, carefully, undo the Brizzel lever, you should be able to mark a second line. In use, move to second line, tighten lever, first line acts as a check you made 90? Just a thought.Mine is 300 miles away in storage, or I would go try this myself. In the past, I have always nipped it up almost tight, then gently rubber malleted it into square before full locking.

Elektra Beckum Hc 260 Manual

Elektra Beckum Planer Thicknesser Hc260 Manual Transfer System

Seemed to work.Sam.